beautypg.com

Grass Valley TR6442i User Manual

Page 49

background image

45

Converting the TR6442i Viper II Rack Mount Unit

15 Install the display circuit board from the previous step to the Throw Down front panel

using the same four screws

16 Install the front plate assembly onto the base of the unit as shown. Carefully align the

connector of the ribbon connector. The pins should go straight in and align.

Once the front plate is properly seated and the tabs inserted into the bottom plate of
the unit, you are ready to secure the plate with the screw previously removed.

Fig. A-13: Securing the front panel

17 Secure the front plate with the two screws as shown in

Figure A-13

.

18 Install the rear plate on to the unit.

To get the tabs into place on the bottom plate of the unit, you must lift the main circuit
board as you did when removing the Rack Mount rear panel.

You may need to give the panel a small amount of pressure in order to the the 4 Wire
(RJ45 type) connectors in place over the EMI tabs.

Fig. A-14: Securing the back panel

19 Secure the back plate to the unit base by re-installing the two screws removed when

taking off the Rack Mount rear panel

20 Install the connector board onto the base. Be careful not to bend the connector pins.