Fiber, Settings web page – Grass Valley 8949MDA-CFR v.1.1.X User Manual
Page 30
30
8949MDA-CFR/-SFR—Instruction Manual
Remote Configuration
Settings Web Page
Use
this
link
The Settings web page for 8949MDA-CFR (
) and
8949MDA-SFR (
) provides a reporting of signal control
for the DA output. This page gives the model, the description and the frame
location and provides controls to perform input configuration.
The parameters for configuration of a 8949MDA module are explained
below:
•
The
Routing Mode
area will be different, depending on the presence and
type of fiber optic submodules. This area shows the available inputs.
Only one input can be selected.
•
Coax In 1
– Selection of J9 BNC coax input.
•
Optic 1 or/and 2
– Selection of the available optical input.
•
Optic Outputs
– when fiber optic outputs are available from the installed
fiber optic submodule, select
Enable
or
Disable
. (Not applicable when a
Dual Receiver (1310NM-DRL is installed).
•
Input Reporting
– choose between
Enable
or
Disable
. The
Enable
parameter
sends alarms to the 8900NET module on the input signals (presence of
signal). The color of arrows on the module Status web page will be
automatically changed.
The
Disable
parameter will change the color of arrows on the Status web
page to gray to show they are not being monitored or reported to upper
level control devices.
•
Input Format
– selection of the input format transported on the HD-SDI or
SD-SDI signal. Refer to the
•
Carrier Detect
– indicates the presence of valid input signal.
•
Locked Rate
– this value is linked to the input bitstream rate detected.
•
Video Format
– this value reports the input format detected.
•
Monitoring Format
– this value indicates the downscaled output format.
•
Composite Color Bar
– this parameter allows the selection of a composite
color bar test pattern on the downscaled outputs.
•
Composite Setup
– this parameter is shown if the
Monitoring Format
is
480i/59.94. Configure as
Setup
or
No Setup
on the composite outputs as
shown in