Status web page – Grass Valley 8949MDA-CFR v.1.1.X User Manual
Page 28
28
8949MDA-CFR/-SFR—Instruction Manual
Remote Configuration
Status Web Page
Use
this
link
The Status web page (
for 8949MDA-CFR) shows the
signal status of the input signal(s) and communication with the frame bus.
Color coding of the display indicates the signal status. Refer to
for an explanation of the color coding.
Note
On the 8949MDA modules, input signals are represented by up to three input
signal arrows. If the status of either input signal changes, it will be reflected
in the color status of the arrow and the Status LED on the module web pages.
To determine specific signal status for DA, refer to the Status web page or the
on-board LED.
•
Under the
Status
title are given the model, the description and the frame
location. Below, the graphic shows the input and output signals. If the
status of either input or output changes, it will be reflected in the color
status of the arrow (linked to the
Input Reporting
parameter) and the
status LED on the module web page.
•
Information about the module, such as Part Number, Serial Number,
Hardware Revision, Firmware Revision 1 (CPLD), Firmware Revision
2 (FPGA), Software Version, and Asset Tag number are given in a prop-
erties section at the bottom of the Status Web Page.
Note
Some modules may display a part number on the Status web page that is dif-
ferent from the one printed on the module circuit board. These part numbers
are completely compatible.
•
On the Status web page, the presence and the type of
Optic Device
installed will be reported in the double bars area, four messages can be
displayed: Missing, RX-RX 1310nm DRL, TX-TX 1310nm DTL or TX-RX
1310nm TRL, depending on the fiber optic submodule installed.
Other module warning messages from the module will also appear in this
area.
Note
The color of the LED present on the top left of each web page is managed by
the 8900NET accordingly to the alarms status.