Cabling, Video input – Grass Valley 8949MDA-CFR v.1.1.X User Manual
Page 19
8949MDA-CFR/-SFR—Instruction Manual
19
Cabling
Cabling
Cabling to the 8949MDA-CFR or 8949MDA-SFR module is done on the
BNCs and the fiber connector on the rear module when an optional fiber
optic submodule is installed.
Cabling of the rear module depends on presence and type of fiber optic
submodule option as listed below:
•
8949MDA-CFR/-SFR without fiber optic submodule option (electrical
only),
•
8949MDA-CFR/-SFR with 1310NM-DRL (Dual Receiver Fiber Optic)
•
8949MDA-CFR/-SFR with 1310NM-DTL (Dual Transmitter Fiber
Optic), and
•
8949MDA-CFR/-SFR with 1310NM-TRL (Transceiver Fiber Optic).
Note
Fiber input and output connections must be cleaned before cabling as
described in
Fiber Optic Cleaning Requirement on page 18
.
Video Input
The 8949MDA-CFR or 8949MDA-SFR will accept any of the video stan-
dards listed in the input specifications in
.
For both module types, the SD or HD video input to the module can be
selected from one of the following three sources, depending on the pres-
ence and type of fiber optic submodule option:
•
Electrical BNC, J9 (always available)
•
Fiber Input RX 1 or RX 2 (requires 1310NM-DRL submodule), or
•
Fiber Input RX 1 (requires 1310NM-TRL submodule).
All three sources can be connected but only be one input can be active at
any time. The active input is configured with local onboard controls (
figuration Switches S1 and S2 on page 13
) or using the Settings web page
). The video input type must also be selected in configuration.