8900net module alarm dip switches – Grass Valley 8900NET v.4.0.0 User Manual
Page 20
20
8900NET Instruction Manual
Status Monitoring and Reporting
8900NET Module Alarm DIP Switches
Two eight-position DIP switches (S1 and S2) enable or disable the overall
status reporting of the frame, including Frame Alarm and SNMP moni-
toring. The current status of these settings is reported on the Frame Alarm
Reporting (
) frame web pages.
Refer to
for the location of S1 and S2 on the 8900NET
module and
and
for the possible settings. A settings table
is also silk-screened on the bottom of the module. Disabling (or filtering) of
fault reports can sometimes be useful in isolating problems in the frame.
Figure 12. Alarm Reporting DIP switches
Note
Disabled faults are still detected by the network GUI but LEDs will be inactive.
Table 2. 8900NET Module DIP Switches
S1
Segmen
t
Left Position (open)
Right Position (closed)
1
PS1 Fault Reporting Enabled
PS1 Fault Reporting Disabled
2
PS2 Fault Reporting Enabled
PS2 Fault Reporting Disabled
3
(Not used) Over Temp reporting is always enabled locally and through SNMP
4
Fan Fault Reporting Enabled
Fan Fault Reporting Disabled
5
Module Fault Reporting Enabled
Module Fault Reporting Disabled
6
Frame Bus Error Reporting Enabled
Frame Bus Error Reporting Disabled
7
Fan Speed Controlled by Temperature
Fan Speed Fixed at Maximum
8
Network Module Control Enabled (remote control via GUI is
enabled)
Network Module GUI is placed in read only mode
S2
Segmen
t
Left Position (open)
Right Position (closed)
1
Status Enabled (enabled alarms are reported over SNMP)
SNMP Reporting is disabled except for Over Temp alarm
2
IP Address (not currently supported)
3
Frame Control Enabled (remote control via GUI is enabled)
GUI for the frame and all modules within is placed in read only mode
4 – 8
(Currently Not Used)
12345678
12345678
S2
S1
Power Supply #1
Power Supply #2
Temperature
Fan
Module
Frame Bus
Fan Speed
NM Control
Status
8900NET
IP Address
Frame Control
Remote
Override
LED
0612_28