Grass Valley 2000NET v3.2.2 - Manual (Page 35)

2000NET Instruction Manual 35
Using the 2000NET GUI
After reading the agreement, click on Accept to finish installing the SNMP
Agent. Clicking the Decline button will abort the SNMP Agent installation.
Figure 24. Installing the SNMP Agent
When the SNMP Agent is successfully installed, the 2000NET Configura-
tion web page will contain the setup items shown in
Figure 25 on page 36 .
Net Card SNMP Trap Reports
The following SNMP trap reports are provided for the 2000NET module:
• Net Card Status (Alarm)
• Hardware Switch (Informational)
SNMP Report Activation Modes
Each report destination has an activation control that can select one of the
following modes of operation:
• CREATE – GO creates a new report destination that becomes active after
the next module reboot.
• CREATE – WAIT creates a new report destination that remains out of
service until the user selects active and then reboots the module.
• ACTIVE changes a NOT IN SERVICE report destination to active after the next
module reboot.
• NOT IN SERVICE changes an active report destination to inactive after the
next module reboot.
• DELETE removes the report destination entry. If the entry was active it
remains active until the next module reboot.
Note Report destination status does not change until the 2000NET module is
rebooted.