Grass Valley 2010RDA - Manual (Page 8)

2 2010/2011RDA Instruction Manual
2010/2011RDA Dual/Quad AES/EBU Reclocking DA
Installation
Installation of the 2010/2011RDA module is a process of:
■ Placing the passive rear module in a rear frame slot,
■ Placing the media module in the corresponding front slot, and
■ Cabling and terminating signal ports.
The 2010/2011RDA module can be plugged in and removed from a 2000
Series frame with power on. When power is applied to the module, LED
indicators reflect the initialization process (see
Power Up on page 8 ).
Module Placement in the 2000 Frame
There are twelve slot locations in both the front and rear of a 3RU frame to
accommodate 2000 Series modules. The 2010/2011RDA module set con-
sists of a front media module and a passive rear module that can be
plugged into any of the 12 frame slots. Each 2010/2011RDA front media
module plugs into the front of the 2000 frame mid-plane. The passive rear
module plugs into the corresponding rear slot to provide the input and
output interface connectors.
To install a 2010/2011RDA module set in the frame:
1. Locate a vacant slot in the rear of the 3 RU frame ( Figure 1 ).
Figure 1. 3 RU Frame, Rear View
Mid-frame motherboard
with power and
communication buses
Rear media module slots 1 – 6 Rear media module slots 7 – 12
8025-04