Grass Valley 2010RDA - Manual (Page 19)

2010/2011RDA Instruction Manual 13
Remote Configuration and Monitoring
The INPUT STATUS OUTPUT MODE display ( Figure 12 ) provides the following
status reporting items for the module:
■ MODE indicates whether the on-board jumper is configured for SINGLE ,
DUAL or QUAD output mode. (Refer to Set Operating Mode on page 10 .)
■ REAR MODULE ID indicates whether the 2000PRM-D ( PRM-D ) or COAX
PRM ( PRM-COAX ) passive rear module is installed. (Refer to 2000PRM-D
Passive Rear Module on page 6 or 2010RDA COAX PRM Passive Rear
Module on page 5 .)
■ INPUT IMPEDANCE indicates the input impedance of the passive rear
module installed as 75 OHM (COAX PRM) or 110 OHM (2000PRM-D).
■ CHANNEL LOCK indicates whether each channel is LOCKED (valid AES ref-
erence signal is present and module is locked to it) or UNLOCKED
(module does not detect a valid AES reference signal).
■ SAMPLE RATE indicates the current input sample rate being detected by
each channel as one of the following: OUT OF RANGE , 32K , 44.1K , 48K, 88.2K
or 96K .
Figure 12. 2010/2011RDA Input Status/Output Mode Display
D
Use
This
Link
Ouput mode
Channel lock status
Type of rear
module installed
Input impedance
Sample rate status
2010RDA Module
installed
2011RDA Module
with PRM-D passive
rear module installed
and set to Quad mode