Grass Valley 2010RDA - Manual (Page 11)

2010/2011RDA Instruction Manual 5
Installation
Cabling
All cabling to the modules is done on the corresponding passive rear
module at the back of the 2000 frame. There are two versions of passive rear
modules available for the 2010RDA, the COAX PRM with 75
Ω
BNC I/O
( Figure 5 ) and the 2000PRM-D with 110 Ω D-connector I/O ( Figure 6 ). The
2011RDA-110 uses only the 2000PRM-D passive rear module.
Refer to the instructions that follow for cabling either the COAX PRM or
2000PRM-D passive rear modules for single, dual or quad mode.
2010RDA COAX PRM Passive Rear Module
The COAX PRM module provides ten 75 Ω (unbalanced) BNC connectors
for single or dual operation with the 2010RDA. Refer to Figure 5 for an
illustration of the COAX PRM passive rear module.
The module must be jumpered during configuration for the desired mode
of operation. Refer to
Set Operating Mode on page 10 .
Figure 5. COAX PRM Passive Rear Module
Refer to Table 1 for single and dual channel cabling.
Note At the back of this manual are overlay cards that can be placed over the BNC
connectors to identify specific single or dual connector function.
Table 1. COAX PRM Cabling Pinouts
Connector Single Mode Dual Mode
J1 Ch 1 In Ch 1 In
J2 Ch 1 Out 1 Ch 1 Out 1
J3 Ch 1 Out 2 Ch 1 Out 2
J4 Ch 1 Out 3 Ch 1 Out 3
J5 Ch 1 Out 4 Ch 1 Out 4
8068_06
COAX
PRM
J6 J7 J8 J9 J10 J5 J3 J4 J2 J1
Single Mode
Dual Mode
Out 1 – 4
CH1 Out 1 – 4 CH2 Out 1 – 4
In 1
CH1 In CH2 In
Out 4 – 8