H3C Technologies H3C Intelligent Management Center - Manual (Page 10)

6
Managing networks with iMC BIMS
CPE devices in a WAN feature large quantity and dynamic IP addresses. Therefore, iMC BIMS uses the
OUI and serial number to uniquely identity a CPE device.
To manage a CPE device in a WAN with iMC BIMS, first complete these operations in the iMC BIMS
system: Configure system settings, add CPE authentication users, and add the CPE device. Then, log in
to the CPE device, configure CPE WAN Management Protocol (CWMP) parameters, which must be the
same as those configured in iMC BIMS. After the CPE device configuration is complete, and the CPE
device actively accesses iMC BIMS, iMC BIMS can manage it.
You can manage the actively connected devices by their privilege, back up their configurations, and
deploy the configuration file and device software for them.
The following sections describe a typical iMC BIMS configuration procedure. Log in to iMC BIMS as an
admin, and then perform the following configurations.
System settings
System settings needed include default polling time, periodic inform interval, device access parameters,
CPE device adding policy, and common password. iMC BIMS provides default settings for some
parameters, and you can modify them as needed.
Log in to iMC BIMS, and then click the System tab to enter the page shown in
Figure 6 .
Figure 6 System Configuration
On the page, click System Settings in the System Configuration area to enter the System Settings page.