H3C Technologies H3C Intelligent Management Center - Manual (Page 80)

71
{
Use the default settings public and 161 for SNMP Community and SNMP Port, respectively.
Make sure the settings are the same as those on the device.
{
Configure an IP address in the Log Source IP field as needed.
The IP address is used when IMC cannot obtain the device interface information through
SNMP. This example does not use this parameter.
{
Select Valid from the NetStream Statistics Identifier list.
{
Select Enable from the NetStream New Feature list.
7. Click OK.
Modifying the UBA server configuration
1. In the Guide to Quick Traffic Analysis And Audit Configuration area, click Server Management.
The Server Management page appears.
2. Click the Modify icon for the UBA server.
The Server Configuration page appears, as shown in Figure 11 .
Figure 11 Modifying the server configuration
3. Keep the default settings in the Basic Information area.
4. Select 90.16.0.8 in the Device Information area in this example.