H3C Technologies H3C Intelligent Management Center - Manual (Page 27)

18
{
FTP Username—Username of the FTP account used by probes to upload data to the UBA
server.
{
Traffic Analysis Log Aggregation Policy—Aggregation policy that is applied to the network
flow records directed to the UBA server.
{
Filter Policy—Indicates whether a filtering policy is applied to network flow records directed to
the UBA server.
{
Usage Threshold of the Database Disk (1-95%)—Threshold for the percent of database disk
utilization defined for the UBA server.
{
When Database Disk Usage Reaches Threshold—Action that is taken when the database disk
usage reaches the threshold specified in the Usage Threshold of the Database Disk field.
Device Information area
{
Device Name—Name of the device that provides network flow data for the UBA server.
{
Device IP—IP address of the device that provides network flow data for the UBA server.
{
Device Description—Description for the device that provides the network flow data for the UBA
server.
Probe Information area
{
Probe Name—Name of the probe that provides the network flow data for the UBA server.
{
Probe IP—IP address of the probe that provides the network flow data for the UBA server.
{
Enable Layer 7 Application Identification—Indicates whether the Layer 7 application
identification is enabled for the probe that provides the network flow data for the UBA server.
{
Enable Special Audit—Special audits that are enabled for the UBA server.
Intranet Monitor Information area
Intranet Information—Intranet IP segments that are added when you modify the server
configuration for the UBA server.
3. Click Back to return to the Server Management page.
Modifying and deploying UBA server configuration
1. Access the Server Management page.
2. In the UBA server list, click the Modify icon for the UBA server you want to modify.
The Server Configuration page appears.
3. In the Basic Information area, modify UBA server parameters as needed:
a. In the Server Name field, enter a new server name. By default, this field displays the loopback
address of the local server when UBA is installed on the same server as the IMC Platform.
b. You cannot modify the Server IP field.
c. In the Server Description field, enter a new description for the UBA server.
d. In the Listening Port field, modify the UDP port number that UBA uses to communicate with the
devices and probes that send traffic data. The default values are 9020, 9021, and 6343.
The listening port numbers in UBA must be the same as that in the listening port configuration
on devices. Otherwise, UBA fails to receive flow records from devices.
e. Configure the FTP Main Directory field, FTP Username field, and FTP Password field.
Make sure the FTP main directory, username, and password settings in UBA are the same as
those you configure for the FTP server set on the UBA server.