H3C Technologies H3C Intelligent Management Center - Manual (Page 25)

16
{
IP—IP address of the probe.
{
Description—Description for the probe.
{
Enable Layer 7 Application Identification—Indicates whether Layer 7 application identification
is enabled for the probe.
3. Click Back to return to the Probe Management page.
Adding a probe
1. Access the Probe Management page.
2. In the probe list, click Add.
The Add Probe page appears.
3. In the Name field, enter a name for the probe.
The name for each probe must be unique.
4. In the IP field, enter the IP address of the probe.
The IP address must be an IPv4 address and must communicate with the UBA server correctly.
5. In the Description field, enter a description for the probe.
6. Select Yes from the Enable Layer 7 Application Identification list if you want UBA to analyze Layer
7 application data. Select No from the Enable Layer 7 Application Identification list if you want
UBA to analyze only Layer 4 application data.
7. Enter the password for the probe in the Probe Password field.
The password must be consistent with the password on the probe. If you have not set a password
on the probe, leave this field empty.
8. Click OK.
Modifying a probe
1. Access the Probe Management page.
2. In the probe list, click the Modify icon for the probe you want to modify.
The Modify Probe page appears.
3. Modify probe parameters as needed.
You cannot modify the IP field. For more information about modifying probe parameters, see
"
Adding a probe ."
4. Click OK.
Deleting a probe
Deleting a probe from UBA does not delete the data received from the probe prior to the deletion.
To delete a probe:
1. Access the Probe Management page.
2. Click the Delete icon for the probe you want to delete.
A confirmation dialog box appears.
3. Click OK.
NOTE:
Once a probe has been deleted, all user behavior audit tasks associated with the probe will be
terminated.