H3C Technologies H3C Intelligent Management Center - Manual (Page 22)

13
The sampling rate is in the range of 1 to 65536. The value of 1 indicates that the sampling rate is
1:1, and the value of 100 indicates that the sampling rate is 1:100. The sampling rate you enter
must be the same as that you have configured on the device. Otherwise, traffic statistics errors
occur. If you have not configured a sampling rate on the device, enter 1, which indicates that the
sampling rate is 1:1.
12. Click OK.
NOTE:
The sFlow Settings field is applicable only to the NTA component.
Adding a data source device by selecting devices from the IMC Platform
1. Access the Device Management page.
2. In the device list, click Add.
The Add Device page appears.
3. Click Select next to the Device IP field.
The Select Devices dialog box appears.
4. Do one of the following:
{
On the Select Devices dialog box, click the By View tab.
Click the Expand icon to the left of the IP View, Device View, or Custom View, and then
select a subview. All devices in the subview are displayed in the Devices Found area:
− IP View—Displays all devices by network segment.
− Device View—Displays all devices by device category.
− Custom View—Displays all devices by custom view and Devices Not In Views. All devices
that do not belong to any view are automatically added to Devices Not In Views.
{
On the Select Devices dialog box, click the Advanced tab.
Specify one or more of the following query criteria:
− Device IP—Enter the IP address you want to query. Select Exact Query if you want UBA to
query the exact IP address you have entered.
− Device IP List—Configure multiple device IP addresses to be searched. Click the Device IP
List Configuration icon . The Device IP List Configuration window appears. Enter one or
multiple device IP addresses in the Input Device IP field (to enter multiple IP addresses, enter
one IP address on each line), and click Add to add the entered IP addresses to the Device
IP List field below.
Repeat the steps above to add all device IP addresses to be searched.
To delete an IP address in the Device IP List field, select the IP address, click Delete, and
click OK.
Make sure the device IP addresses to be queried have been added to the Device IP List
field. To clear the Device IP List field, click the Clear icon .
− Device Label—Enter a name for the devices you want to add. UBA supports fuzzy
matching for this field.
− Device Status—Select device status from the Device Status list.
− Device Category—Select a device type from the Device Category list.
− Device Series—Select a device series from the Device Series list.