H3C Technologies H3C Intelligent Management Center - Manual (Page 79)

70
Configuring UBA
Adding the NetStream device to UBA
1. Click the Service tab.
2. From the navigation tree, select Traffic Analysis and Audit > Settings.
The Settings page appears.
3. In the Guide to Quick Traffic Analysis And Audit Configuration area, click Device Management.
The Device Management page appears.
4. Click Add.
The Add Device page appears, as shown in
Figure 10 .
Figure 10 Adding a device
5. Add a device to UBA:
{
If the device has been added to the IMC Platform, click Select to select it. Settings for SNMP
Community, SNMP Port, and Log Source IP are optional.
{
If the device is not added to the IMC Platform, enter the device's IP address and name in the
Device IP and Name fields, respectively. Settings for SNMP Community and SNMP Port are
required.
The device IP address is the management address of the Netstream card.
6. Perform the following tasks, as shown in Figure 10 :