H3C Technologies H3C SecBlade IPS Cards - Manual (Page 22)

5-3
To do… Use the command… Remarks
Enter system view system-view —
Set the user connection timeout
time
idle-timeout minutes [ seconds ]
Optional
5 minutes by default
Specifying the Login Password
You can use the password command to specify the password for Console port and Telnet connection.
You can also use the reset web-admin-user-password command to restore the password for user
admin to the default, that is, admin.
Follow these steps to specify the login password:
To do… Use the command… Remarks
Enter system view system-view —
Specify the login password password
Optional
H3C by default
Restore the default password of
user admin
reset web-admin-user-password
Optional
By default, the password of the
user admin is admin.
z
By default, there is a user with the username and password both being admin on the device.
z
If the user admin has been deleted, the reset web-admin-user-password command does not
take effect.
Collecting Diagnostic Information
You can use the collect diag_info command to generate a file named h3c.debug for the debugging
information generated by the system, and upload the file to the specified TFTP server to save it. When
the device fails, you can send the generated file to the device maintainer to locate the fault.
Follow these steps to collect diagnostic information:
To do… Use the command… Remarks
Enter system view system-view —
Collect diagnostic information collect diag_info ip-address Required