Configuring a combo port, Displaying and maintaining interfaces, 2 displaying and maintaining interfaces – H3C Technologies H3C SecBlade IPS Cards User Manual
Page 12
2-2
To do…
Use the command…
Remarks
Set the speed of the Ethernet
interface
speed
{ 10 | 100 | 1000 | 10000 |
auto
}
Optional
auto
by default
10-GE interfaces only support the
10000
keyword. The optical
interface of a Combo port does not
support this command. Support for
the keywords of the command
varies with device models.
Shut down the Ethernet interface
shutdown
Optional
By default, an Ethernet interface is
up.
To bring up an Ethernet interface,
use the undo shutdown
command.
Configuring a Combo Port
The term Combo port refers to two Ethernet interfaces (usually one optical interface and one electrical
interface) on the device panel which share the same internal forwarding interface of the device. A
Combo port can work as either of the two interfaces, but only one at a time. Enabling one interface
automatically disables the other one.
Follow these steps to set the state of a Combo port:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter Combo port view
interface
interface-name —
Enable the specified interface of
the Combo port
combo
enable { copper | fiber }
Optional
By default, the electrical interface
of a Combo port is enabled.
Displaying and Maintaining Interfaces
To do…
Use the command…
Remarks
Display the operational
status and information of the
specified interface
display interface
[ interface-name ]
Available in any view