H3C Technologies H3C WA2600 Series WLAN Access Points - Manual (Page 20)

15
Figure 12 Alternative method for installing an omnidirectional antenna
NOTE:
In Figure 12 , the antenna pole is not fixed on the cement pier. Instead, the antenna pole is fixed by
welding two angle steel bars between the antenna pole and the lightning rod pole.
Connecting cables
WARNING!
Before connecting any cable, make sure that all power lines are disconnected and locked out and that no
hazardous voltage is present on the neutral (N) line.
CAUTION:
Make sure that the outer sheath of cables is intact and does not absorb moisture to protect the AP from
water leak.
External cables may include antenna cable, Ethernet cable, fiber cable, grounding cable, and power
cord.
Connecting the antenna cables
The antenna cables connect the antenna ports (2.4 GHz and 5 GHz) to the outdoor antennas.
To connect the antenna cables: