Startup process – H3C Technologies H3C MSR 20-2X[40] User Manual
Page 36
29
For local configuration, after you power on the router, you can see the startup banner. See section
3.
After completing the power-on self-test (POST), the system asks you to press
prompt appears, you may proceed to configure the router.
Startup Process
After power-on or during the reboot process, the following information is displayed on the terminal:
System application is starting...
Booting Normal Extend BootWare........
The Extend BootWare is self-decompressing...................
Done!
**************************************************************************
* *
* MSR20-40 BootWare, Version 3.01 *
* *
**************************************************************************
Compiled Date : Jul 7 2008
CPU Type : MPC8248
CPU L1 Cache : 16KB
CPU Clock Speed : 400MHz
Memory Type : SDRAM
Memory Size : 384MB
Memory Speed : 100MHz
BootWare Size : 4096KB
Flash Size : 4MB
cfa0 Size : 64MB
CPLD Version : 130.0
PCB Version : 2.0
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Press Ctrl+B to enter the extended Boot ROM menu. Otherwise, the system goes into the program
decompression process.
NOTE:
Press Ctrl + B within six seconds after “Press Ctrl+B to enter extended boot menu...” appears to enter the
extended Boot ROM menu. Otherwise, the system goes into the program decompression process. You
need to restart the router if you want to enter the extended Boot ROM menu after the decompression
process.
starting to get the main application file--cfa0:/main.bin!
......
......