H3C Technologies H3C MSR 20-2X[40] - Manual (Page 35)

28
Figure 24 Setting terminal type
Powering on the Router
Checking before power-on
Check according to the following items before powering on the router.
• Whether the power cord and PGND wire are correctly connected.
• Whether the voltage of the power supply complies with the requirement of the router.
• Whether the console cable is correctly connected, whether the PC or terminal for configuration is
open, and whether the settings are done.
• Whether the CF card is loosed.
WARNING!
Before powering on the router, the user should be aware where the switch of the power supply to the
router is located, so that the power supply can be disconnected in time once accidents occur.
Powering on the router
• Turn on the site power.
• Turn on the power switch on the router.
Checking/operating after power-on
After powering on the router, check that:
1. The LEDs on the front panel show that the router is operating normally.
2. The console terminal displays normally.