H3C Technologies H3C S6800 Series Switches - Manual (Page 62)

54
Verifying the configuration
1. Verify the configuration on the VTEPs (for example, Switch A).
# Verify that all VXLAN tunnel interfaces are up.
[SwitchA] display interface tunnel
Tunnel 1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1464
Internet protocol processing: disabled
Last clearing of counters: Never
Tunnel source 1.1.1.1, destination 2.2.2.2
Tunnel protocol/transport UDP_VXLAN/IP
Tunnel 2
Current state: UP
Line protocol state: UP
Description: Tunnel2 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1464
Internet protocol processing: disabled
Last clearing of counters: Never
Tunnel source 1.1.1.1, destination 3.3.3.3
Tunnel protocol/transport UDP_VXLAN/IP
# Verify that the Ethernet service instances are associated to the correct VSIs, and the VXLAN
tunnels have been assigned to the correct VXLANs.
[SwitchA] display l2vpn vsi verbose
VSI Name: vpna
VSI Index : 0
VSI State : Up
MTU : 1500
Bandwidth : -
Broadcast Restrain : -
Multicast Restrain : -
Unknown Unicast Restrain: -
MAC Learning : Enabled
MAC Table Limit : -
Drop Unknown : -
Flooding : Enabled
VXLAN ID : 10000
Tunnels:
Tunnel Name Link ID State Type
Tunnel1 65537 UP Manual
ACs:
AC Link ID State