H3C Technologies H3C S6800 Series Switches - Manual (Page 18)

10
Configuring basic VXLAN features
Licensing requirements
VXLAN requires a license. For information about feature licensing, see Fundamentals Configuration
Guide.
VXLAN configuration task list
Tasks at a glance Remarks
(Required.) Creating a VXLAN on a VSI N/A
(Required.) Configuring a VXLAN tunnel N/A
(Required.) Assigning a VXLAN tunnel to a VXLAN
To extend a VXLAN to remote sites, you must
assign VXLAN tunnels to the VXLAN.
(Required.) Mapping an Ethernet service instance to a VSI
Perform this task to assign customer traffic to
VXLANs.
(Optional.) Managing MAC address entries
You can add static remote MAC addresses.
When network attacks occur, disable
remote-MAC address learning to prevent the
device from learning incorrect remote MAC
addresses.
(Optional.) Configuring a multicast-mode VXLAN
By default, the VTEP floods VXLAN traffic in
unicast mode. If the network is multicast dense,
configure the VTEP to flood VXLAN traffic in
multicast mode.
(Optional.) Confining unknown-unicast floods to the local site
Perform this task to suppress unknown-unicast
floods to the transport network.
(Optional.) Configuring the destination UDP port number of
VXLAN packets
N/A
(Optional.) Configuring VXLAN packet check
Perform this task to check incoming VXLAN
packets, including the following items:
• UDP checksum.
• 802.1Q VLAN tags in the inner Ethernet
header.
(Optional.) Enabling ARP flood suppression N/A
(Optional.) Configuring VXLAN packet statistics N/A