H3C Technologies H3C S6800 Series Switches - Manual (Page 32)

24
# Verify that the VTEP has learned the MAC addresses of remote VMs.
display l2vpn mac-address
MAC Address State VSI Name Link ID/Name Aging
cc3e-5f9c-6cdb Dynamic vpna Tunnel1 Aging
cc3e-5f9c-23dc Dynamic vpna Tunnel2 Aging
--- 2 mac address(es) found ---
2. Verify that VM 1, VM 2, and VM 3 can ping each other. (Details not shown.)
Multicast-mode VXLAN configuration example
Network requirements
As shown in Figure 10 :
• Configure VXLAN 10 as a multicast-mode VXLAN on Switch A, Switch B, and Switch C to provide
Layer 2 connectivity for the VMs across the network sites.
• Manually establish VXLAN tunnels and assign the tunnels to VXLAN 10.
• Enable remote-MAC address learning.
Figure 10 Network diagram
Table 1 IP address assignment
Device Interface IP address Device Interface IP address
Switch A: Switch C:
VLAN-interface 11 11.1.1.1/24 VLAN-interface 13 13.1.1.3/24
Switch D: Switch E:
VLAN-interface 11 11.1.1.4/24 VLAN-interface 13 13.1.1.5/24
VLAN-interface 21 21.1.1.4/24 VLAN-interface 23 23.1.1.5/24