Verifying the configuration – H3C Technologies H3C S6800 Series Switches User Manual

Page 31

[SwitchC-vsi-vpna-vxlan10] tunnel 3

[SwitchC-vsi-vpna-vxlan10] quit

[SwitchC-vsi-vpna] quit

# On FortyGigE 1/0/1, create Ethernet service instance 1000 to match frames from VLAN 2.

[SwitchC] interface fortygige 1/0/1

[SwitchC-FortyGigE1/0/1] service-instance 1000

[SwitchC-FortyGigE1/0/1-srv1000] encapsulation s-vid 2

# Map Ethernet service instance 1000 to the VSI vpna.

[SwitchC-FortyGigE1/0/1-srv1000] xconnect vsi vpna

[SwitchC-FortyGigE1/0/1-srv1000] quit

[SwitchC-FortyGigE1/0/1] quit

Verifying the configuration

Verify the VXLAN settings on the VTEPs. This example uses Switch A.
# Verify that the VXLAN tunnel interfaces on the VTEP are up.

[SwitchA] display interface tunnel 1

Tunnel1

Current state: UP

Line protocol state: UP

Description: Tunnel1 Interface

Bandwidth: 64kbps

Maximum Transmit Unit: 1464

Internet protocol processing: disabled

Last clearing of counters: Never

Tunnel source 1.1.1.1, destination 2.2.2.2

Tunnel protocol/transport UDP_VXLAN/IP

# Verify that the VXLAN tunnels have been assigned to the VXLAN.

[SwitchA] display l2vpn vsi verbose

VSI Name: vpna

VSI Index : 0

VSI State : Up

MTU : 1500

Bandwidth : -

Broadcast Restrain : -

Multicast Restrain : -

Unknown Unicast Restrain: -

MAC Learning : Enabled

MAC Table Limit : -

Drop Unknown : -

Flooding : Enabled

VXLAN ID : 10

Tunnels:

Tunnel Name Link ID State Type

Tunnel1 0x5000001 Up Manual

Tunnel2 0x5000002 Up Manual

ACs:

AC Link ID State

FGE1/0/1 srv1000 0 Up