Trill configuration example, Network requirements – H3C Technologies H3C S6800 Series Switches User Manual
Page 32
25
Task Command
Display information about the TRILL
VR unicast FIB.
display trill vr-fib [ count | mac mac-address vlan vlan-id ]
Display the TRILL VR multiport unicast
MAC address table.
display trill vr-route [ vrid vrid ] [ vlan vlan-id ] [ mac-address
mac-address ]
Clear dynamic running statistics of
the TRILL process.
reset trill
TRILL configuration example
Network requirements
As shown in
, a data center network has three layers: the core layer, the distribution layer, and
the access layer. A port connected to a higher layer device is an uplink port, and a port connected to a
lower layer device is a downlink port.
Configure TRILL in the network as follows:
•
Enable TRILL on both uplink and downlink ports of access layer devices, and enable TRILL on
downlink ports of distribution layer devices.
•
Configure two TRILL distribution trees that are rooted at RB 1 and RB 2. Configure a higher priority
for RB 1 to be a distribution tree root.
•
Configure a TRILL VR and multicast routing for the TRILL network to forward Layer 3 traffic.
Figure 8 Network diagram