H3C Technologies H3C S6800 Series Switches - Manual (Page 16)

9
Figure 6 Two TRILL neighbors are established for a port (1)
Figure 7 Two TRILL neighbors are established for a port (2)
Configuration procedure
To enable TRILL:
Step Command Remarks
1. Enter system view. system-view N/A
1. Enable TRILL globally
and enter TRILL view.
trill By default, TRILL is disabled globally.
2. Return to system view. quit N/A
3. Enter Layer 2 Ethernet
or aggregate interface
view.
interface interface-type
interface-number
N/A
4. Enable TRILL on the
port.
trill enable By default, TRILL is disabled on a port.
Configuring the system ID and nickname for an RB
The system ID and nickname of an RB are identifiers of the RB in the TRILL network.
• System ID—Unique identifier of an RB in the TRILL network. The system ID can be automatically
assigned or manually configured.
• Nickname—Address of an RB in the TRILL network. The address can be automatically assigned or
manually configured. When multiple RBs in the TRILL network have the same nickname, the RB with
the highest priority uses the nickname. When the RBs also have the same priority, the RB with the
Traditional Ethernet
switch
RB 1
RB 2 RB 3
TRILL enabled port