ATL Telecom IP250 - Manual (Page 26)

26 15
5.7 SNMP
The following page is used for configuring the device’s SNMP manager. Configure the SNMP
Trap Host IP address and community, the SNMP read and write community parameters, and
the SNMP System Description and System Object ID parameters.
Press “Save SNMP Settings” to apply the new values. These settings will only take effect
when the device is rebooted.
3.5 OOB Signaling
The following page allows configuration of the out-of-band signaling options for SIP. Select
whether OOB telephone event signaling is to be done using the SIP INFO message, or to be
done via RFC2833 RTP signaling.
3.6 Tos/Diffserv
The following page is used to configure the Type-of-Service/Diffserv byte values which are
to be used in the IP header of all transmitted SIP signaling packets and RTP packets. The
ToS/DiffServ byte values are entered as two-digit hexadecimal values. If no special ToS/Diff-
Serv value is to be used for a particular traffic type, enter”00” or leave the setting empty.
Press “Save ToS/DiffServ Settings” to save these new settings.