ARM Electronics RT8-16CD User Manual

Page 19

BASIC OPERATION

-14-

Install the supplied AP software on your NB/PC. Then, log into the DVR with the supplied AP software for the

following default DVR settings.

‧ The DVR default IP address: 192.168.1.10

‧ The DVR default account / password: admin

‧ The DVR default port: 80

2) Set DVR network setting in “SYSTEM CONFIG”  “Network” of the supplied AP:

In the “SYSTEM CONFIG”  “Network” of the supplied AP, select the “Static IP” in “IP TYPE” section. And then

type the “Server IP”, “Gateway”, “Net Mask” and “Web Port” (1~9999) information obtained from your ISP.

Press ”APPLY” button to confirm the setting.

3) Login your DVR via an Ethernet or dial-up network.:

After setting up the network information of the DVR and connect it to the network, you can use the IP address / Port

/ Account / Password you just entered in the supplied AP software to log into your DVR remotely.

Note: Before changing the network properties of your PC/NB, please write down the original network

properties in case you need to recover the properties later.

3.6.2 DDNS Apply

You need to apply a DDNS account before setting PPPoE or DHCP connection. DDNS is a service for transforming

the dynamic IP corresponding to a specific “Hostname”. For DDNS setup, please refer to the steps below.

‧ Go to a website which provides free DDNS services and apply a “Hostname”.

For example, go to

files without this message by purchasing novaPDF printer (