ARM Electronics DVRCD120 - Manual (Page 30)

User’s Manual
29
Press CALL key for 3 seconds, the BNC Monitor will be given the same
function as the VGA Monitor, except Playback and Search function. You can
use the BNC Monitor to take over the Full-featured MPEG-4 DVR a the same
time, as if the two monitors are connected to two individual Full-featured
MPEG-4 DVRs.
When using this function, a small figure ( ) appears in the mid-button side
of the two monitors—the yellow one represents the monitor is now accessed.
NOTE: When the VGA monitor is now under Dome Control Mode’ or the
OSD setup mode, or has not exit the OSD menu, the BNC monitor
cannot access the OSD setup menu.
4.2 Sequence Setup
This section introduce you how to view in sequence mode with both Main
Monitor and Call Monitor, if connected. Sequence function can avoid manually
backtracking and give more flexibility while surveillance.
4.2.1 Sequence with Main Monitor
Automatic sequence function can be used in any view mode. Select certain
view format and press SEQ to toggle the automatic sequential sequence,
press ESC to stop sequencing. The figure below displays the 4-camera and
9-camera sequencing view modes.