ARM Electronics DVRCD120 - Manual (Page 19)

User’s Manual
18
NOTE: Please go to the menu to enable or disable the
password protection.
NOTE: For Full-featured MPEG-4 DVR Turbo Model, Call key will still
take effect when the unit is under key locked mode. It is used for
accessing “Two Main Monitor Out” function.
DOME
Press the key to enter dome control mode. Please refer to OSD Menu Setup
Guide, Section Dome Control for detailed controlling operation.
3.2 Install HDD to the Unit
There is a cartridge positioned on the front panel, and it allows user to install a
swappable HDD. There will be two possible situations when you install a HDD
into your DVR.
• If you install whole new HDDs, the DVR will format it and add it into your
database automatically.
• If you install an used HDD which doesn’t have the DVR format, the DVR
will show up “1 disk(s) with wrong data format! Please format them and
then add to the database manually”. Then please follow the steps as we
describe below:
- Please enter the menu with the administrator privilege and access the
“Database Information” section
- Please access the “Internal(or external) Disks”
- You can see the available disks, please select “format” to format it
- After formatting is OK, please select “Add” to add them into your
database.
3.3 Power Up / Down the Unit
If you must shut down the Full-featured MPEG-4 DVR for any reason, please
use the proper shut down and power up procedures to avoid damaging to
your DVR unit.
To Power Up the Unit
Check the used type of power source before plug in your DVR unit first (the
acceptable power input is between AC110V ~AC240V), and turn on the unit
using the power switch on the rear panel.