ARM Electronics DVRCD120 - Manual (Page 24)

User’s Manual
23
3.6.1 Record Mode
The Record Mode is for selecting resolution and recording rate. The relative
record settings, such as preset configuration, will follow the record mode
setting. In normal circumstance, we recommend you to select <720 × ×× ×
240@120PPS> (<720× ×× ×288@100PPS> in PAL format).
Move the cursor to and press ENTER, then select a Record
mode using UP / DOWN keys.
NOTE: After changing the Record Mode setting, the warning message
“This will FORMAT ALL HARDDISKS and LOAD THE FACTORY
DEFAULT CONFIG!” will be shown on the screen. Press ENTER to
confirm the selection, then the unit starts to format the hard disks and
load the factory default settings, or press ESC to abort.
We strongly recommend that you back up the programmed
configuration before making any changes on Record Mode settings.
3.6.2 Schedule Setup
The Schedule Setup is used to set the day and night time, or weekend
recording schedule. Select from the Record Setup menu
and press ENTER; the following menu is displayed.
Schedule Setup
1. Day Time Start
2. Day Time End
3. Night Time Start
4. Night Time End
5. Weekend Schedule
6. Weekend Start
7. Weekend End AM06:00
PM06:00
PM18:00
AM06:00
YES
Fri AM18:00
Mon PM06:00
• Make appropriate changes of the start time of Day and Night Time using
Direction keys.
• Press ENTER to confirm the settings or ESC to cancel.
• If you want to have a weekend record, choose to enable the
Weekend Schedule in advance and then set the Weekend Start/End time.
Press ESC to back to previous page.