ARM Electronics DVRCD120 - Manual (Page 31)

User’s Manual
30
4.2.2 Sequence with Call Monitor
Users are allowed to use the Full-featured MPEG-4 DVR front panel to
control a call monitor display without having to access the Main menu. Two
viewing modes can be displayed on call monitor: Sequence display and
Single camera display. To program the call monitor sequence, see OSD Menu
Setup Guide, Section Sequence Setup.
Follow the steps to control the call monitor.
• Press the CALL key on the front panel to enter call monitor control mode,
the message “Call Mode” will be shown on the bottom-left of the screen.
Press 1-16 Key To Select Channel
Press SEQ To Enable Sequence
Call Mode
• Press CHANNEL key to display the associated camera on call monitor.
• Alternatively, press SEQ repeatedly to display the sequence of cameras
previously programmed in Call Monitor Schedule menu.
• Press ESC to return the front panel to Main monitor control mode.
4.3 Searching Recorded Video
The Full-featured MPEG-4 DVR is capable of searching and playing back
recorded video by date and time or events. Entering the specific date and time
of the wanted video, the unit will then search for the matched video and play it
on the monitor. Alternatively, user can search event video by selecting
channel as well.
In live or playback mode, press SEARCH to enter the Search menu, which is
shown as follows.
Search
----------------------------Search By Time----------------------------
From:
End:
Start Time: 2005/01/01 00:00:00
2005/05/01 00:00:00
2005/01/01 00:00:00
Begin Playback
----------------------------Search By Event----------------------------
Select Channel: CH1 CH2 CH3 CH4
Event List