Aqua Lung WTX Buoyancy System - Manual (Page 36)

1. Remove the inflator hose from the power inflator body
by gripping the grooved sleeve over the quick disconnect
coupling with your thumb and forefinger. Slide the sleeve
back.
2. Remove the port plug from an MP port on the regulator
using an appropriately sized wrench.
WARNING: DO NOT connect the inflator hose
to a high pressure (HP) port (greater than 200
psi / 14 bar). This may cause the hose to burst
when pressurized, which can result in serious
injury. If you are unsure which regulator port
is medium pressure (MP) or high pressure
(HP), consult your regulator owner’s manual
or your dealer before attaching the hose.
3. Check to ensure the o-ring is present and in good
condition. Screw the threaded end of the hose into the
port and tighten to 40 in-lbs (46 kg-cm) with a 9/16”
wrench.
© 2014 Apeks
Table of Contents