Amped Wireless AP600EX - High Power Wireless-N 600mW Pro Access Point - Manual (Page 46)

AP600EX USER’S GUIDE
45
The Pro Access Point is not functioning and the Power LED keeps blinking
a. The network (Ethernet) cable you are using is not compatible with the Pro Access Point. Replace the
network cable between the PoE Adapter and your router/switch with a Non-PoE Cable.
Tip: How to check whether your cable is a PoE cable or a Non-PoE cable:
Check the connector tip of the network cable to see if there are 4 wires or 8 wires. Non-PoE
cables use only 4 wires.
b. If you have a computer or network device attached to the LAN port of the Pro Access Point, check
that the cable is a Non-PoE cable. Some unsupported PoE devices may cause power conflicts with the
Pro Access Point.
I do not have Internet access when connecting to the Pro Access Point
a. Your router or original network may not have Internet access. First check to see if you are able to
access the Internet by connecting directly with your router. If you cannot, there is a problem with
your router that needs to be fixed first. If you are able to access the internet, continue with the
following troubleshooting options below.
b. Check that the Pro Access Point is correctly connected to your router or network switch. The router
should be connected to the Network Port on the PoE Adapter (Not directly to the Pro Access Point).
The PoE adapter should be connected to the Pro Access Point’s PoE port. After the connection has