Amped Wireless UA600 - High Power Wireless USB Adapter - Manual

Insert the Setup CD
— R E A D F I R S T —
SETUP GUIDE
UA600
High Power Wireless-300N 600mW USB Adapter
C. Continue the Driver Installation
Follow the instructions that appear and click
Install to continue the installation.
D. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes and click Finish to restart.
E. Insert the High Power USB Adapter
After the computer has fully rebooted, locate two
available USB ports and insert the USB Adapter.
Windows should automatically begin installing the
driver for use with the USB Adapter. If only one
USB port is available, insert the USB connector
labeled Primary .
F. Connect to a Wireless Network
Locate the Wireless Icon in the Windows System
tray (bottom right-hand corner) and click it to
view available wireless networks. Highlight your
desired network and click Connect .
G. Connect to a Wireless Network
If the network you are trying to connect to has
security enabled you will need to enter it here.
B. Start the Driver Installation
If prompted, click Yes to begin the installation.
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file
Install Software
Windows 7 and Vista
2
Follow the Instructions for your Operating System:
C. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes and click Finish to restart.
D. Insert the High Power USB Adapter
After the computer has fully rebooted, locate two
available USB ports and insert the USB Adapter.
The Found New Hardware Wizard should appear.
If only one USB port is available, insert the USB
connector labeled Primary .
E. New Hardware Wizard
When the New Hardware Wizard appears and asks
to search for software, select No, not this time.
Click Next to continue .
F. New Hardware Wizard
When prompted by the New Hardware Wizard to
install the software, select Install the Software
Automatically (Recommended) and click Next .
B. Start the Driver Installation
Click Next to begin the installation. Follow the
instructions that appear and click Install t o
continue.
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file
G. Connect to a Wireless Network
Once Windows has completed the software installation
locate the Amped Wireless Utility on your desktop and
open the software by double-clicking the icon. Select
the Available Network tab to view nearby networks.
H. Connect to a Wireless Network
Highlight the network that you wish to connect to
and double-click it to connect. If your network
has security enabled, you can enter it in the
Network Key field and click OK .
Windows XP and 2000
Amped Wireless
USB Wireless-N Driver
and Utility
The menu page should appear.
Select the instructions for your operating system
below and install the driver for the USB adapter.
Windows Instructions: This Side
Mac Instructions: Back Side
Do not insert the USB Adapter until after the
software/driver has been fully installed.
1
3
Need Help? Give us a call.
Phone: 888-573-8820
Email: [email protected]
Web: www.ampedwireless.com/support
?
IMPORTANT: DO NOT INSERT THE USB ADAPTER
UNTIL THE DRIVER HAS BEEN INSTALLED