Amped Wireless UA1000 - High Power Wireless-N 500mW Directional USB Adapter - Manual

Insert the Setup CD
— R E A D F I R S T —
SETUP GUIDE
UA1000
High Power Wireless-N 500mW Directional USB Adapter
C. Continue the Driver Installation
Follow the instructions that appear and click
Next to continue the installation.
D. Restart your Computer
A prompt will appear asking you to restart your
computer. Select Yes and click Finish to restart.
E. Insert the High Power USB Adapter
After the computer has fully rebooted, locate
two available USB ports and insert the USB
Adapter. Windows should automatically begin
installing the driver for use with the USB
Adapter. If only one USB port is available,
insert the USB connector labeled Primary .
B. Start the Driver/Utility Installation
If prompted, click Yes to begin the installation.
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file
Install Software
Windows 7 and Vista
2
Follow the Instructions for your Operating System:
A. From the Menu page, select Install Software
If the Menu page does not appear, browse the
CD drive and double-click the Autoload.exe file.
E. Found New Hardware Wizard
When prompted by the Found New Hardware
Wizard to install the software, select
Install the Software Automatically
(Recommended) and click Next .
Windows XP and 2000
The menu page should appear.
Follow the instructions for your operating system
below and install the driver for the USB Adapter.
Windows Instructions: This Side
Mac Instructions: Back Side
Do not insert the USB Adapter until after the
software/driver has been fully installed.
C. Insert the High Power USB Adapter
After the computer has fully rebooted, locate
two available USB ports and insert the USB Adapter.
The Found New Hardware Wizard should appear.
If only one USB port is available, insert the USB
connector labeled Primary .
1
3
Need Help? Give us a call.
Phone: 888-573-8820
Email: [email protected]
Web: www.ampedwireless.com/support
?
B. Restart your Computer
After the driver installation, a prompt will
appear asking you to restart your computer.
Select Yes and click Finish to restart.
D. Found New Hardware Wizard
When the Found New Hardware Wizard appears
and asks to search for software, select
No, not this time . Click Next to continue .
F. Connect to a Wireless Network
Once Windows has completed the software
installation locate the Amped Wireless Utility
on your desktop and open the software by
double-clicking the icon. Select the Available
Network tab to view nearby networks.
Highlight the network that you wish to connect
to and double-click it to connect or click,
Add to Profile , to have your computer connect
automatically when the network is available.
Amped Wireless
Utility
F. Connect to a Wireless Network
Once Windows has completed the software
installation locate the Amped Wireless Utility
on your desktop and open the software by
double-clicking the icon. Select the Available
Network tab to view nearby networks.
Highlight the network that you wish to connect
to and double-click it to connect or click,
Add to Profile , to have your computer connect
automatically when the network is available.
Amped Wireless
Utility
G. Connect to a Wireless Network
If your network has security enabled, you can
enter it in the Network Key field and click OK .
IMPORTANT: DO NOT INSERT THE USB ADAPTER
UNTIL THE DRIVER HAS BEEN INSTALLED
H. Position the Directional Antenna
For optimal performance, position the adapter
towards the direction of your wireless network.
Wireless
Router
G. Connect to a Wireless Network
If your network has security enabled, you can
enter it in the Network Key field and click OK .
H. Position the Directional Antenna
For optimal performance, position the adapter
towards the direction of your wireless network.
Wireless
Router