Amer Networks SRPM24 - Manual (Page 37)

SRPM24
„ RW: Read write. Enables requests accompanied by this community string to display MIB-object
information and to set MIB objects.
„ Click Add button.
„ To remove the community string, select the community string that you have defined and
click Remove button. You cannot edit the name of the default community string set.
Trap Manager:
A trap manager is a management station that receives the trap messages generated by the Device. If no
trap manager is defined, no traps will be issued. Create a trap manager by entering the IP address of the
station and a community string. To define a management station as a trap manager, assign an IP address,
enter the SNMP community strings, and select the SNMP trap version.
„ IP Address: Enter the IP address of the trap manager.
„ Community: Enter the community string.
„ Trap Version: Select the SNMP trap version type—v1 or v2c.
„ Click Add button.
„ To remove the community string, select the community string listed in the current managers field
and click Remove button.
There are three types of trap:
Standard: Includes DHCP Setting, Authentication Failure, and Cold Start.
Power over Ethernet: Includes DC disconnect, PD disconnect, Overload, Short Circuit, Over
Temperature, Port off by Power Management.
UPS: Includes Power Disconnect, Power Fault, Battery Low, and Power Over Temperature.
[Note]
Power over Ethernet traps also record in System Log and E-mail Alert.
Email Alert
You can set up the mail server IP, mail account, password, and forwarded email account for receiving the
event alert.
„ Email Alert: Enable or disable the email alert function.
„ SMTP Server IP: Assign the mail server IP address (when Email Alert enabled, this function will
then be available).
„ Sender: Type in an alias of the device in complete email address format, e.g. [email protected],
to identify where the event log comes from.
36