Amer Networks SRPM24 - Manual (Page 12)

SRPM24
Power On
Connect the power cord to the power socket on the rear panel of the 24-port Managed PoE Midspan
switch. Connect the other side of the power cord to the power outlet. The internal power supply of the
24-port Managed PoE Midspan switch works with voltage in the range of 100-240 Vac, frequency
50~60Hz. Check the power indicator on the front panel to see if power is properly supplied.
Desktop Installation
Set the Device on a sufficiently large flat space with a power outlet nearby. The surface where you put
your Device should be clean, smooth, level and sturdy.
Make sure there is enough clearance around the Network device to allow attachment of cables, power
cord and allow air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Network device is grease and dust free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the Rubber Feet to each corner on the bottom of the Network device. These
footpads can prevent the Network device from shock/vibration.
Attaching Rubber Feet to each corner on the bottom of the Device
11