Airaid 1022 - Manual (Page 2)

Instructions Revision
10.07.14
6. Double check your work. Make sure there is no foreign ma-
terial in the intake tract. Make sure all clamps, connectors, hos-
es, nuts, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the resonator and tighten the bolt that secures it to the
intake manifold. Reinstall the intake tube, tighten the hose clamp,
and reconnect the intake temperature sensor.
Re-connect the negative battery cable!
4. Reinstall the factory bolts thru the throttlebody and ECONOAID
Booster and tighten to the manufacturer's specifications. 3. Install the ECONOAID Booster onto the intake manifold as
shown. (The tab on the ECONOAID Booster may be rotated 90° to
the left if desired.) Now install the gasket and make sure it is seated
correctly over the two alignment pins on the intake manifold. Make
sure the ECONOAID logo faces the throttlebody.
Fiber Gasket ECONOAID
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order
number D-520-4. This decal must be placed in
plain view inside the engine compartment.
Failure to do may prevent you from passing a
smog inspection.
*2010-13 model years are not CARB Approved