Airaid 200-612-P - Manual

Parts List
#1 Poweraid Spacer x1
#2 6mmx55mm Bolts x3
#3 6mm Flat Washers x3
#4 Fiber Gasket x2
#5 Linkage Plates x3
#6 6mmx16mm Screws x3
#7 1/16” NPT Fitting x1
#8 1/16” NPT Plugs x2
Tools Required For Installation
4mm & 10mm Socket
5/16” Socket
Ratchet and Extension
5/32” Allen Wrench
Installation Instructions
Part Number: 200-612-P
Poweraid Spacer With
Powerport For Most 99-02
GM Trucks and SUVs W/
4.8L,5.3L,6.0L Gas Engines &
2004 GTO 5.7L
1. Disconnect the negative battery cable!
Loosen one bolt and remove the beauty cover. Pry
the tube from the clamp on the radiator hose.
Loosen the hose clamps on each end of the intake
tube and remove the tube. 2. Using a 10mm socket, remove three nuts on the
throttle body.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID
.
Photo shown with other manufacturer’s products
* Optional: Included in the hardware pack is (1) 3/16” vacuum fitting, this may be used for a vacuum gauge. If
PowerPorts are utilized, install necessary fittings before installing spacer on vehicle. Other 1/16” NPT fittings may
be installed , such as power adders.