Airaid 310-511 User Manual

Parts list

Parts List

#1 Poweraid Spacer

#2 6mmx50mm Bolts

#3 6mm Flat Washers

#4 Fiber Gasket

#5 1” Round Spacer

#6 6mmx40mm Bolts

Tools Required For Installation

10mm Socket

5/16” Socket

Ratchet and Extension

Installation Instructions
Part Number 310-511
Poweraid Spacer For 91-02
Jeep TJ, YJ Wrangler
XJ Cherokee 2.5L

1. Disconnect the negative battery cable!
A). Loosen the hose clamp that holds the factory
intake resonator to the throttle body. B). Loosen the
hose clamp that connects to the airbox. C). Remove
two bolts on top of the valve cover. D). Disconnect
the breather hose on the back of the resonator.

2. Remove the intake tube and resonator from the
vehicle.

Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction

manual carefully before proceeding with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM -
5:00 PM MST Weekdays for questions regarding fit or instructions that are not clear to you. Your
Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are miss-
ing, or were damaged during shipping. If any parts are missing, please contact AIRAID.

3. With a 10mm socket, remove the four bolts that
hold the throttle body to the intake manifold.

4. With the throttle body set aside, remove the gas-
ket and clean the surfaces of the manifold and
throttle body.