Airaid 200-615 - Manual

Parts List
#1 Poweraid Spacer x1
#2 6mmx114mm Stud x2
#3 6mmx70mm Stud x1
#4 6mmx30mm bolt x1
#5 6mmx35mm bolt x1
#6 6mm Flat Washer x5
#7 6mm Nut x3
#8 1/2” Long Round Spacer x2
#9 Fiber Gasket x1
Installation Instructions
Part Number 200-615
Poweraid Spacer For 2001-07
Chevy Silverado/Silverado “Classic”
GMC Sierra/Sierra “Classic”
4.3L V6
1. Disconnect the negative battery cable!
Loosen the hose clamps on the factory intake tube. Re-
move the intake tube and set it aside.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the instruction manual carefully before proceed-
ing with the installation. Contact AIRAID @ (800) 498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instruc-
tions that are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, please contact AIRAID.
3. With a 10mm deep well socket, remove the throttle
body, throttle cable support bracket, and throttle cable
bracket nuts. Using a 6mm 12 point socket, remove the
rear stud from the throttle body. Disconnect the harness
plugs on the throttle body. 4. Set the throttle body and brackets aside. Remove the
factory throttle body studs. Install two 6mm x 114mm
studs (#2) in the front mounting holes, and one 6mm x
70mm stud (#3) in the rear. Using 4mm and 10mm sock-
ets, remove the factory throttle cable bracket studs.
2. Disconnect the breather hose elbow from the intake hat.
Remove the intake hat, and hold down nut, and save them
for reuse.
Tools Required For Installation
10mm Deep Well Socket
4mm Socket or Wrench
6mm 12 Point Wrench
8mm Wrench
5/16” Socket
Ratchet and Extension