Airaid 310-616 - Manual

Parts List
#1 Poweraid Spacer x1
#2 6mmx60mm Bolts x4
#3 6mm Flat Washers x4
#4 Fiber Gasket x1
Tools Required For Installation
5/16” 6 point & 10mm Socket
Ratchet and Extension
Installation Instructions
Part Number 310-616
Poweraid Spacer For 2007-11
Jeep Wrangler
3.8L V6
1. Disconnect the negative battery cable!
Loosen 2 hose clamps on each end of the factory
intake tube. Slide the red locking tab, and then
squeeze the black tab, and disconnect the intake
tube temperature sensor wiring harness. Remove the
tube from the vehicle. 2. Using a 6 point 5/16” socket, remove the 4 bolts
that hold the throttle body to the intake manifold.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.
C.A.R.B. E.O. Number Good Up Thru 2009 Models Only