Airaid 350-635 - Manual

Parts List
#1 Poweraid Spacer x1
#2 O-Ring x1
#3 6mm x 60mm Hex Bolts x4
#4 6mm Flat Washers x4
Tools Required For Installation
5/16” & 10mm Sockets
Ratchet & Extension
Installation Instructions
Part Number 350-635
2010 Dodge Challenger,
Charger, Chrysler 300C,
Jeep Cherokee SRT-8
6.1L ENGINE ONLY
1. Disconnect the negative battery cable!
A) Using a 5/16” socket, loosen the hose clamp on
the throttle body end of the factory intake tube.
Move the factory intake tube up and out of the way
of the throttle body. B) Disconnect the throttle
body motor harness and the air temperature sensor. 2. Using a 10mm Socket, remove the 4 bolts that
hold the throttle body to the intake manifold.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
Thank you for selecting AIRAID.
B
A