Airaid 1018 - Manual (Page 2)

Instructions Revision
3/21/11
7. Double check your work. Make sure there is no foreign
material in the intake tract. Make sure all clamps, connectors,
hoses, nuts, and bolts are secure.
Reconnect the negative battery cable.
ECONOAID 2688 E Rose Garden Ln. Phoenix, AZ 85050 (888) 876-4676 www.ECONOAID.com
5. Reinstall the intake hat and tighten the wing nut. Reconnect
the crankcase breather hose. Reconnect the intake tube and
tighten the clamp.
ECONOAID
4. Reinstall the throttlebody onto the intake manifold and
tighten all three bolts to the vehicle manufacturer’s specifica-
tions. Reconnect the two wiring harnesses. Reinstall the bolt
thru the throttle cable bracket and into the throttlebody. Before
starting the engine, open and close the throttlebody to make
sure there are no obstructions. 3. Install the ECONOAID Throttlebody booster against the
intake manifold with the logo facing the throttlebody. Next
install the supplied gasket between the ECONOAID and the
throttlebody.
Fiber Gasket
Included with your ECONOAID Throttlebody
Booster is a decal with the California Air Re-
sources Board ( C.A.R.B. ) Executive Order
number D-520-4. This decal must be placed in
plain view inside the engine compartment. Fail-
ure to do may prevent you from passing a smog
inspection.