Airaid 1018 User Manual

Part number 1018

Parts List

#1 ECONOAID

#2 Gasket

1. Disconnect the negative battery cable!
Remove the plastic wing nut on the air intake hat behind the
throttlebody. Loosen the hose clamp that secures the flexible
intake tube to the throttle body hat. Disconnect the crankcase
breather hose. Roll the air intake hat towards the front of the
vehicle to remove it, and set it aside.

2. A.) Remove the three bolts that secure the throttlebody to
the intake manifold. B.) Remove the bolt that secures the
throttle cable bracket to the throttlebody. C.) Lift up the tabs,
and disconnect the two wiring harnesses of the drivers side of
the throttlebody. Lift the throttlebody off of the intake mani-
fold and set it to the side.

Thank you for purchasing the ECONOAID Throttlebody Booster. Please read the instruction manual carefully before pro-

ceeding with the installation. Contact ECONOAID @ (888) 876-4676 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit
or instructions that are not clear to you. Your ECONOAID Throttlebody Booster was carefully inspected and packaged. Check that
no parts are missing, or were damaged during shipping. If any parts are missing, please contact ECONOAID.

Tools Required For Installation

5/16”Deep, 5.5mm, 10mm Sockets

Ratchet and Extension

Part Number 1018

1996-00 Chevrolet, GMC Truck & SUV

5.7L V-8

1996-06 Chevy Silverado, GMC Sierra
4.3L V-6
2007 Chevrolet Silverado “Classic”

GMC Sierra “Classic”

4.3L V6

1996-04 Chevrolet S-10, GMC Sonoma

4.3L V6

U.S. Pat. #7,665,442