Airaid 311-770 - Manual (Page 3)

10. Install the coupler and two
#60 hose clamps on the
throttle body as shown. Do
not tighten hose clamps.
Fasten the factory breather
hose to air conditioning line
using the supplied zip tie.
11. Install the supplied grommet
into Airaid MIT as shown.
12. Carefully install the
temperature sensor into the
Airaid MIT as shown. Make
sure it’s pushed all the way in
and the plug is connected to
the wire harness.
13. Install the MIT into the hump
hose first, and then into the
throttle body coupler. Adjust
to fit, and tighten the hose
clamps.
14. Re-install the engine cover by
firmly pushing it back into the
grommets.
15. Re-install the oil fill cap.
16. Check for any foreign material
in the intake path. Re-check
your work for tightness. Re-
connect the negative battery
cable.
First Second