Filter identification – Airaid 200-785 User Manual
Page 2
Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
13. Double check your work. Make sure all Clamps are
tight and reconnect the negative battery cable.
10. The 23 1/2” Hose is to be on the Drivers side. As
shown.
11. The 10 1/2” Hose is to be used on the Passenger
side as shown.
REV.05.30.14
WARNING! If your vehicle has a Vehicle Emission Control Information decal affixed to the factory air box and
it is removed, a new replacement label must be obtained and installed in a readily visible position in the engine
compartment in order to remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog
check. Replacement labels can be ordered from your local dealership. Regulations state that the VECI label shall
not be affixed to any equipment which is easily detached from the vehicle. Label placement, under the hood on a
painted surface is recommended.
10 1/2”
23 1/2”
FILTER IDENTIFICATION
720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red
722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require
oil. Service air filter as needed by
cleaning
with
common
non-
petroleum all-purpose household
cleaner and water. Simple Green®,
Formula 409® or equivalent works
great. Apply cleaner to outside of air
filter and allow to soak. Then flush
filter clean from the inside out with a
garden hose and repeat steps if nec-
essary. Do not apply high pressure
water or air to clean filter. Allow fil-
ter to air dry and reinstall.
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
12. Secure the hose ends with the supplied Speed
Clamps.