Airaid 860-425 - Manual

Part List
1 Airaid Premium Filter 1
2 8-32 x .38L BHCS 2
3 #8 Flat Washer 2
4 #8 Kep Nut 2
Installation Instructions
Part Numbers :
860-425, 861-425 & 863-425
2011-2014 Jeep Wrangler 3.6L
3. Disconnect the crankcase breather line in the top of the
airbox. Remove the entire airbox as an assembly by un-
seating it from the mounting grommets in the inner fend-
er and lifting upward.
4. Drill out the rivet heads on the factory airbox and re-
move the air scoop. Remove any remaining rivet pieces
from the air box and discard them.
A.
B.
C.
D.
Disconnect The Negative Battery Terminal!
1. Remove the engine cover and set it aside. 2. A.) Disconnect the air temp sensor in the factory
intake. B.) Remove the two 6 mm bolts holding the
intake tube to the fan Shroud. C.) Loosen the Clamps
on both sides of the factory intake tube. D.) Unclip the
coolant line from the intake tube and remove it from the
vehicle.
NOTE: Installation of this air filter requires modifica-
tion of the OEM airbox. Please read the installation
instructions in their entirety before beginning the pro-
cess.