Airaid 510-607 - Manual (Page 2)

5. Install the Poweraid spacer (#1) next to the intake
manifold, and the fiber gasket (#4) next to the throt-
tle body. Insert the four provided 6mm bolts (#2),
and washers (#3), and tighten in a cross pattern, to
the vehicle manufacture’s specifications.
6. Re-install the intake tube and tighten the hose
clamps. Re-connect the vacuum lines, wiring har-
ness clip, and breather hose. Re-install the bolt thru
the clamp on the air conditioning hose into the in-
take tube. Re-install the beauty cover and nuts.
Re-connect the negative battery cable!
Instructions Revision
07/12/06
The sound of power...The “whistle” means its working!
3. Disconnect the breather hose, and two vacuum
lines from the back of the intake tube. Remove the
clip from the back of the intake tube that holds the
wiring harness, these will all be re-connected later.
Remove the intake tube from the vehicle. 4. With a 10mm socket, remove three bolts and
one nut from the throttle body. Slide the throttle
body away from the intake manifold, and remove
the remaining stud.
Spacer
Gasket
Included with your Poweraid Spacer is a sticker with a California Air Resources Board
(C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of
the engine compartment. Failure to do so may prevent you from passing a smog inspection.